2018年3月15日 · Ronin's Grips - Polymer80 Pistol Frame M35 Drill Bits 3mm & 4 mm - These quality drill bits are sized for drilling Polymer80 pistol frames for their pins. This package includes one 3mm drill bit (approx. 2.95-2.97mm) and one 4mm drill bit (approx. 3.95-3.96mm).

2024年12月16日 · I’m hoping to complete a set of 5 to Glock and Glock M arrays to be fired at one distance using reduced size targets and correct spacing between targets. If I can get it done I’ll put the target sizes and spacing measurements …

2024年12月7日 · It has that drill bit / Phillips screwdriver head and I think it's called the extreme defender because I don't think that 38 will expand out of a JFrame barrel so it's better than a hollow point or wad cutter. There are many better options in my honest opinion in 9 mm that have been proven and actually cost quite a bit less.

2023年4月11日 · get a bolt extractor,,drill the stripped torx head for a little depth. Make sure your tiny drill will match the tiny extractor. Find out the size of the screw Bolt The worn out torx should get your drill bit close to center,,be careful with your drilling depth,,of course don’t damage the threads with a to large of a width drill

2013年2月19日 · Drill 27/64 Drill bit 23/64 Drill bit Measuring tape framers square or square (any straight line measuring device) Rubber mallet or hammer (hammer softly) Center punch (optional, just for starting drill bit) Router (optional) 1/2" Chamfer bit Pencil Electric tape (optional) Used for drill stop Materials: 3/8" x 2" turning (pin) 7/16" x 2 ...

2020年3月19日 · So I went to Lowe's and bought the Irwin 8 - 32 tap and drill bit set. Along with that I bought several $4 to $5 Dewalt drill bits 3/32 7/64 and 9/64. These were labeled as Dewalt Split Point, very sharp. And 2 of the 8-32 set screws with the Allen head, these were roughly 3/8 inch long. I never used the 9/64 bit in this build or repair.

2024年12月2日 · This 567BL injection molded polymer belt loop is designed for use on standard 3-hole pattern holsters. It can be adjusted for cant and allows for cross draw. This belt loop comes in seven sizes to fit belt widths from 1.5” to 2.25” (38mm - 58mm) and …

2012年3月18日 · First I ground the end of the drill bit flat and sharp, to punch 1/2" disks. This worked, but made gas checks with very short sides. It was also hard to center the bullets on the gas checks. Then I went back and ground the end of the drill bit down to about 40 caliber, and ground a cutting shoulder a little way back from the tip.

2024年10月24日 · I have a few of both, and I prefer the p32 by a large margin. It recoils a little less, making 1 handed firing easier, and the weight difference feels more substantial than it should when carrying it in the pocket.

2019年10月22日 · Glocktalk is a forum community dedicated to Glock enthusiasts. Come join the discussion about Glock pistols and rifles, optics, hunting, gunsmithing, styles, reviews, accessories, and more!