2018年9月22日 · It's good the OP posted the lubrication guide as Glock's lubrication instructions have slightly changed from years ago (when I was taught to put a drop on each of the 4 rail pieces). Also, when I first started with Glocks and had both never taken one apart or seen one taken apart, I didn't understand exactly where to put the drop of oil for the ...

2014年12月8日 · No. I think you're looking at the Barrel Lubrication image in which case I think you're correct that the square dot refers to the top flat edge of the barrel. My question is about the Slide Lubrication (4 drops) image. I understand that the slide rails should get 1 drop each and the front underside of the slide should get a drop.

2012年3月4日 · Glock 31 OD Green- LaserMax guiderod laser,Larry Vickers Tango Down extended magazine release,Factory Glock night sights,Ghost Ultimate 3.5,Lone Wolf competition spring kit,22&15rd mags! Save Share

2005年2月7日 · After a recuest from a Glock talk friend Ill post these pics where the parts that should be lubricated are circled in red. * remember to lube with just a bit, wipe off any excess. I got this info from the Glock video by Bill Wilson in the Routine Maintenance & cleaning section, a pretty nice video to learn some basics. *glock shown is my G17

2017年8月29日 · Tetra grease on frame rails for lubrication. A little goes a long way. Also a tiny bit on the connector tip. For protection against rust on the rest of the metal parts...CorrosionX. I just wipe it on and wipe it off. All that is left is a very thin film. BTW...oil is for protection from rust. Grease is for lubrication. :supergrin:

2015年12月28日 · No. I think you're looking at the Barrel Lubrication image in which case I think you're correct that the square dot refers to the top flat edge of the barrel. My question is about the Slide Lubrication (4 drops) image. I understand that the slide rails should get 1 drop each and the front underside of the slide should get a drop.

2009年11月20日 · Presumably Glock expects that people will leave the copper lubricant in place and so they don't make a point of stating that area should be attended to during lubrication. By the way, not too much later, the range owner/operator retired, closed the …

2023年6月23日 · Hello, I have a question about lubing (oiling) my Glock 19 Gen 5. The manual says to put a drop of oil where the rear end of the trigger bar touches the connector.

2010年2月5日 · Don't lube the trigger, its nylon 66 plastic that is self lubricating. If the trigger is too stiff you can try the famous "25 cent trigger job" and you will notice some difference - there are no miracles here but it did make my 26 trigger a little smoother.

2012年3月4日 · lubrication points 17111 Views 26 Replies 18 Participants Last post by jbomb1119 , Feb 17, 2016 Jump to Latest shiflet Discussion starter · Mar 4, 2012